WIKA CPH6200-S1 Betriebsanleitung Seite 20

Hand-Held Pressure Indicator
CPH6200-S1 / CPH6200-S2
GB
20
Starting logging:
By pressing ´Store/Quit´ for 2 seconds the logger operation will be
called. The display will show:
By pressing ´Store/Quit´ again the recording will be initiated.
After that the display shows 'St.XXXX' for a short time whenever a
measuring is recorded. XXXX is the number of the measuring 1 ... 4000
or 10000.
If the logger memory is full, the display will show:
The recording automatically will be stopped.
If the Low-Power-Logger-function is selected („Lo.Po = on") the device
switches itself off as soon as the memory becomes full.
Stopping the logging manually:
By pressing the ´Store/Quit´ key, recording can be manually inter-
rupted. The following choice then appears:
Stop
recording
The selection can be made by key: ´Max´ and key: ´Min´.
Key ´Store/Quit´ enters the choice.
If you try to switch off the instrument during a logging cy-
cle, you will also be asked if you wish to stop recording. The
device can only be switched off after the recording has been
stopped!
The Auto-Power-Off-function is deactivated during logging!
WIKA Operating Instructions Hand-Held Pressure Indicator
Do not stop
recording