Herunterladen Inhalt Inhalt Diese Seite drucken

Configuration - WIKA CPH6200-S1 Betriebsanleitung

Vorschau ausblenden Andere Handbücher für CPH6200-S1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Hand-Held Pressure Indicator
CPH6200-S1 / CPH6200-S2
Menu
Param.
GB
„Menu"
SEt
Set Alarm: Alarm function configuration
AL.
AL.
[1,2,DIF]
AL.Lo
[1,2,DIF]
AL.Hi
[1,2,DIF]
SEt
Set Logger: Logger function configuration
LoGG
Func
CYCL
Lo.Po
SEt
Set Clock: Setting of real time clock
CLOC
CLOC
dAtE
YEAr
12
Setting
Meaning
or
on
Alarm function on, with audio alarm
no. So
Alarm function on without audio alarm
oFF
No alarm function
Min-Range ...
Min alarm limit
... AL.Hi
(not when AL.oFF, Min-Range is the lower display range of the
connected sensor)
AL.Lo ...
Max alarm limit
... Max-Range
(not when AL.oFF, Max-Range is the upper display range of the
connected sensor)
CYCL
Cyclic: logger function 'cyclic logger'
Stor
Store: logger function 'discrete value logger'
oFF
No logger function
1 ... 3600
Cycle time for cyclic logger [seconds]
on / oFF
Low-power logger with very low power consumption (only if cyclic
logger with slow measuring rate)
HH:MM
Clock: set time hours:minutes
TT.MM
Date: set time day.month
YYYY
Year: set time year
* If there is existing data in the logger memory, the menus/parameters
cannot be accessed! If these need to be adjusted, the logger
memory must first be cleared! (see Section 3)
** This menu can oly be invoked if a refering sensor is connected
to connection 1. When using a second sensor at connection 2 then
changes are taken over.

2. Configuration

To change device settings, press the ´Set/Menu´ key for 2 seconds.
This will access the configuration menu (main display: "SEt").
Pressing the ´Set/Menu´ key again scrolls down the menus, pressing
the ´Tare´ key scrolls across to the associated parameters, which can
then be selected with the ´Tare´ key.
The parameters can be altered using the ´Min´ or ´Max´ keys. Pressing
the ´Set/Menu´ key again saves the settings and returns you to the
main configuration menu.
The ´Store/Quit´ key exits the configuration and returns you to stand-
ard measuring mode.
WIKA Operating Instructions Hand-Held Pressure Indicator
*
*
*
*
*
*
*

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Cph6200-s2

Inhaltsverzeichnis