Clatronic ar 736 Bedienungsanleitung Seite 71

Connection
Connect the device as shown in the diagram.
Note:
• Do not attach the removable control panel until after connec-
tion of the cables.
• Please use loudspeakers with an impedance of 4 ohm.
• The loudspeaker cables must be unearthed.
• The signal connected via the cinch outputs is only played
back through the rear loudspeakers.
Important Information
for installing your carradio!
1. The screws (h) of the transport locking device should
be removed before installation, as otherwise the CD
cannot be inserted.
05-AR 736 CD_MP3_NEU 71
2. The device is designed for the minus pole of the battery,
which must be connected to the body of the vehicle. Please
check this before installation.
3. When installing/connecting your device please note that not
every vehicle is equipped with an "ISO connection". In this
case we recommend the use of an ISO adapter specifi cally
designed for your vehicle.
Adapters are available from car accessory shops and/or
from your vehicle workshop.
4. Depending on the specifi c car type, different wiring connec-
tion of the „Duration +" wire (Constant current connection)
are available. (However, this is necessary for storing the
radio stations).
In order to guarantee all functions, installation in line with
these instructions is essential. In cases of doubt please
contact an authorised car workshop.
5. The angle of inclination when a car radio is installed must
not exceed 20°, as in the case of greater angles of inclinati-
on the function of the car radio (CD Player) can no longer be
guaranteed.
6. Depending on the specifi c car type, interferences can be
possibly arise during radio/CD operation. These interfe-
rences can avoided easily with an additional Interferences
fi lter. Your car radio is originally prepared with an Interfe-
rence Filter already.
In these case, please contact your authorized car dealer.
7. When installing your radio please ensure that there is
enough space at the rear of the radio to ensure suffi cient
cooling.
8. For the antenna connection there are two different norms.
The fi rst of these is the old (50 ohm) version with a long pro-
truding round contact on the vehicle and a round socket on
the radio end. The second is the ISO-standardised antenna
plug (150 ohm). Adapters for both formats are available from
accessory manufacturers and/or your car workshop.
Important information for VW/Audi vehicles: The active
antenna requires voltage on the shielding of the antenna
coaxial cable, without which reception is unsatisfactory. An
antenna adapter with phantom power supply will solve this
problem.
Operating Instructions
1. If the front control panel is removed while the radio or CD is
on, the device is automatically switched off.
2. If the interior of the vehicle becomes very hot, for example
after standing in direct sunlight for a prolonged period, do
not switch on the player until the inside of the vehicle has
cooled down a little after you have been driving for a few
minutes.
3. In order to keep the removable control panel in a safe place
you should always use the protective case provided.
4. Playback of CDs produced by the user cannot be guaran-
teed due to the large variety of software and CD media
available.
71
18.09.2006, 11:02:14 Uhr