Cutting Techniques; Maintenance/Cleaning - Parkside PHS 450 A1 Bedienungsanleitung/Originalbetriebsanleitung

• Always work away from the mains
power outlet. Set the cutting direction
before starting work. Ensure that the
power cable is kept well away from the
working area. Never lay the cable over
the hedge, where it could easily be
caught up in the trimmer blades.
• Avoid overstraining the equipment dur-
ing work.
• There is a hole in the impact protection
( 1) and the bottom of the appliance
to hang the appliance (e.g. while tak-
ing a break from working) (see "wall
bracket").
Pull out the power plug im-
mediately if the cable is dam-
aged, badly twisted or has
been completely cut through.
There is a risk of injury from
electric shock!

Cutting Techniques

• Cut thick branches beforehand using a
branch clippers.
• The double-sided cutter bar enables cut-
ting in both directions or, with a swing-
ing action, from one side to the other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
• In case of horizontal cutting, move the
hedge trimmer in a sickle-shaped move-
ment to the edge of the hedge, so that
cut branches fall to the ground.
• In order to achieve long straight lines,
the placing of tensioned guiding cords
is recommended.
Cutting Shaped Hedges:
It is recommended that hedges be cut in
a trapezoidal shape, in order to prevent
stripping off of the lower branches. This
corresponds to the natural plant growth
and allows the hedge to thrive optimally.
During cutting, only the new annual
growths are reduced and thus a dense
branching and a good screen will develop.
1. Cut the sides of a hedge first. To do
this, move the hedge trimmer in the
direction of growth from bottom to
top. If you cut down from the top, the
thinner branches will move out, which
may result in some areas having sparse
growth or holes.
2. Cut the top edge, according to taste,
in a flat shape, roof shape or rounded
shape.
3. Trim young plants to the required
shape. The main growth should re-
main undamaged until the hedge has
reached the planned height. All other
shoots are lopped off to half size.
Care of Free-Growing Hedges:
Free-growing hedges are not shaped when
cut, although they must be regularly main-
tained so the hedge does not become too
high.

Maintenance/Cleaning

Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
This will prevent damage to the
equipment and any resulting per-
sonal injury.
Pull out the power plug before car-
rying out any work on the equip-
ment. There is a risk of electrocution
or of injury from moving parts.
GB IE
25