Hitachi YUTAKI M-Serie Bedienungsanleitung Seite 18

UNIT INSTALLATION
(Unit: mm)
Around sides are open
6.2 PLACE PROVISION

Concrete foundation
• Foundation shall be on a level surface and it is
recommended to be 100-300 mm higher than ground level.
• Use M10 anchor bolts to fix the unit to the foundation.
(Foundation bolts, nuts and washers are not included, and
must be field supplied).
• Drain water might turn into ice on cold weather areas.
Therefore, when installing the unit on a roof or a veranda,
avoid the draining on a public area since it may become
slippery.
É
174
Ë
Ê
8 PMML0342B rev.1 - 03/2016
All manuals and user guides at all-guides.com
0<L≤1/2H→A≥350
1/2H<L≤H→A≥450
H=1380
900
1250
1450
Ì
Í
Around sides are open with obstacles above
Nº
 Drain water
 Drain water place
 Concrete base
 Foundation bolt
 Mortar charge
• The whole of the base of the Yutaki M unit should be
installed on a foundation. When using vibration-proof mat,
it should also be positioned the same way. When installing
the Yutaki M unit on a fieldsupplied frame, use metal plates
to adjust the frame width for stable installation as shown in
below figure.
Yutaki M unit is
unstable
Frame
CORRECT
Yutaki M unit is
stable
Frame
Recommended Metal Plate Size
• (Field-Supplied) Material: Hot-Rolled Mild Steel
• Plate (SPHC) Plate Thickness: 4.5 T
0<L≤1/2H→A≥600
1/2H<L≤H→A≥1200
H=1380
Description
INCORRECT
57 mm
Base width of Yutaki M unit
60mm
Frame with
(Field supplied)
57 mm
Base width of Yutaki M unit
Metal plate
100mm or more