Printing A Measurement Results; Printing Calibration Results - Mettler Toledo FiveEasyPlus FEP20 Bedienungsanleitung

Baud rate:
Data bit:
Parity bit:
Stop bit:
5.5.2 Printing a Measurement Results
If a printer is connected to the FEP20, a print-out is automatically generated after each endpointed
measurement or calibration.
The format for the print-out following a pH measurement is:
EP, Value, Unit, Temp.
AE 4.01pH 25.0ºC MTC
The details for the second line are:
AE 4.01pH
| |
| |
| ------------------- pH value
------------------------- AE for Auto-End-Point,
The format for the print-out following a mV measurement is:
EP, Value, Unit, Temp.
AE 930mV 25.0ºC MTC
The print-out in case of an error message is:
EP, Value, Unit, Temp.
Error2
5.5.3 Printing Calibration Results
The print-out for a 2-point calibration is:
Buffer1
mV1
Temp.1
Buffer2
mV2
Temp.2
Slope
Offset
ATC/MTC
The print-out for a 3-point calibration is:
Buffer1
mV1
Temp.1
Buffer2
mV2
Temp.2
Buffer3
mV3
Temp.3
Slope
Offset
ATC/MTC
12 Operating the instrument
1200 bps
8 bit
None
1 bit
25.0ºC MTC
| ---- ATC or MTC
----------- Temperature value
ME for Manual-End-Point
4.01pH
178mV
25.0ºC
7.00pH
-0mV
25.0ºC
101%
-0mV
MTC
4.01pH
178mV
25.0ºC
7.00pH
-0mV
25.0ºC
9.21pH
-130mV
25.0ºC
100%
-0mV
ATC