Teufel Alpha Interlock Gebrauchsanweisung Seite 35

Drive the nails in until they are
level with the surface of the
fabricating post.
transition between the
fabricating post and the
model should be smooth.
Blend in with sanding
Tie o at
screem if necessary.
groove
Nails
3
5.
Pull a nylon hose over the
fabricating post and the
model. Tie off the hose at
the groove on the fabricating
post. (Fig. 4)
Tie o at
groove
4
Alpha Interlock Suspension Systems
6.
Note: The
(Fig. 3)
To fabricate a thermoplastic
socket, proceed to the next
section. To fabricate a lamina-
ted socket, proceed to
„For a Laminated Socket".
Pull the rest of the nylon
hose down onto the model.
Cut a small hole in the nylon
hose to expose the dowel
pin. (Fig. 5/6)
Cut hole in hose
5
6
Cut hole in hose
ES
FR
User Manual EN
D D
DE
EN-11