Declaration Of Conformity - Scheppach dms 1200 Vario Originalanleitung

Declaration of Conformity

We herewith declare,
Holzbearbeitungsmaschinen GmbH, Günzburger Str. 69,
D-89335 Ichenhausen
that the machine described below due to its con struc tion
and design and in the version delivered by us complies
with the relevant provisions of the following EC Directives.
In case of a modification of the machine this declara tion
ceases to be valid.
Machine description:
Wood Turner Lathe
Machine type:
dms 1200 vario
Applicable EC Directives:
EC machine directive 98/37/EG (< 28.12.2009),
EC machine directive 2006/42/EG (> 29.12.2009),
EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Applied harmonized European standards
EN 292-1, EN 292-2, EN 294, EN 55014, EN 50082-1, EN
60555-2, EN 60 204-1
Notified body within the meaning of Annex VII
TÜV Rheinland, Product Safety GmbH, 51101 Köln
Engaged for:
EG-Baumusterbescheinigung 9859 10402
Place, date:
Ichenhausen, 08.06.2009
Signature:
On behalf of Wolfgang Windrich
Problem
Motor doesn't start
Drilled holes become
larger than the drill bit
Work piece flatters
while working
Tool rest or tailstock
cannot be clamped
14 english
Scheppach Fabrikation
Trouble shooting
Possible Cause
a) No electricity
b) Defective switch, condenser
c) Defective extension cord
Headstock and tailstock are not parallel.
a) Working piece becomes loose
while working
b) Work piece is not properly centered
c) Rotational speed is too high
Setting the eccentric clamping
von
Help
a) Check fuse
b) Have an electrician inspect unit
c) Unplug cord, inspect and replace, if
necessary
Set up headstock according to the tailstock
tip. Insert carrier into the drilling spindle for
this and position the tailstock with tip up to a
distance of approx. 1°mm.
a) Follow the instructions in the operating
manual
b) Follow the instructions in the operating
manual
c) Select a lower rotational speed
Return the hexagonal nut at the bottom side
about ½ rotation with the socket spanner