Installation; Installation Instructions - Medion p 62010 Bedienungsanleitung

82339 DVD-Autoradio DE Content.book Seite 12 Mittwoch, 29. April 2009 8:41 08

Installation

Installation instructions

Before the installation, disconnect the car battery! Risk of short-circuit
and electric shock!
The hand brake cable and the cable for the rear view camera (see
page 16) may only be connected by specialists. Have this installation
performed by an authorised workshop if you do not have the necessary
skills!
Check if the terminal assignment of your vehicle matches the assignment
at the car radio (see "ISO block assignment", pg. 13).
Do not install the cables under tension, not across sharp edges or close to
parts that could become heated. Make sure you do not kink the cables or
twist them.
Insert the device into the proper slot or choose an installation location that
will not affect the driver's normal ability to drive.
Connect the cable shortly before finally installing the device. Ensure it has
been connected correctly and that the system is working properly.
If changes have to be made to the vehicle, consult your vehicle dealer/
specialist garage.
Make sure that device is installed in such a way that injuries cannot occur
due to heavy braking.
If the device is installed at an angle of over 30°
off the horizontal, this may reduce its optimal
output capacity.
Avoid installing the device near strong heat
(e.g. direct sunlight or heated air), dust, dirt or
strong vibrations. This can damage the device.
You must follow these instructions precisely
during the assembly. Before reconnecting the car battery, check all of the
connections.
EN-12
Maximum installation angle