Troubleshooting - Scheppach Basa 5.0 Originalanleitung

We recommend:
• The swinging segments of the bench, the saw-
band tensioning unit and the guide of the cutting
height adjustment unit must always move easily.
Treat these parts with a lubricant spray when
necessary to maintain these functions.
• Clean the sawband regularly. Wood leaves resin
remnants which stick to the sawband and impair
working safety and performance.
• Keep the bench surface free of resin.
• Do not use cleaning agents or thinners which are
easily flammable or which emit harmful vapors to
clean the sawband and bench.
Use the concentrated resin remover special
accessory.
• Check sawbands regularly for faults. Replace
Failure
Motor does not start
GB
Incorrect motor rotation direction
Sawband slips or jumps down
Burn marks on wood
Sawband jams
faulty sawbands immediately.
• Check saw bench insert.
Replace wom saw bench insert.
• Rubber lining of the band wheels
The rubber lining of the band wheels becomes
ripped and worn by the metal sawband over time.
Exact sawband alignment is then no longer
possible. Working safety and performance are
impaired.
Replace the band wheels!
Replacement wheels can be ordered from your
scheppach dealer as with allother replacement
parts.
• Check the setting of the sawband guide regularly
and readjust it if necessary.
Remove the sawband guide for readjustment.

Troubleshooting

Possible cause
a) No current in the socket
b) Switch or capacitor defective
c) Electrical extension line defective
d) Incorrect connection line 3~400 V
e) Housing lid open (limit switch)
Incorrect connection
a) Upper band wheel
b) Saw band guide
c) Incorrect saw band
d) Fence not parallel to sawband
a) Sawband dull
b) Incorrect sawband
c) Incorrect cutting speed
d) Fence not parallel to sawband
a) Sawband dull
b) Sawband sticky with resin
c) Saw band guide
GB
Solution
a) Check mains fuse
b) Have checked by electrician
c) Pull mains plug, check, replace
d) 5-line connection, at 1,5 mm² diameter
e) Close housing lid exactly
Reverse polarity of wall socket by electrician
a) Carry out side correction according to
Fig."9"
b) Set according to Fig. „10" and „11"
c) Select according to table
d) Set fence according to Fig. „4"
a) Replace sawband
b) Select according to table
c) Set cutting speed according to figure „6"
d) Set fence according to Fig „4"
a) Replace sawband
b) Clean sawband
c) Set according to Fig. „10" and „11"