Notes On Electromagnetic Compatibility (Emc) - Beurer EM 70 Gebrauchsanleitung

• consequential damage arising from a fault in this product (how-
ever, in this case, claims may exist arising from product liability or
other compulsory statutory liability provisions).
Repairs or an exchange in full do not extend the warranty period un-
der any circumstances.

16. Notes on electromagnetic compatibility (EMC)

WARNING
• The device is suitable for use in all environments listed in these in-
structions for use, including domestic environments.
• The use of the device may be limited in the presence of electro-
magnetic disturbances.This could result in issues such as error
messages or the failure of the display/device.
• Avoid using this device directly next to other devices or stacked
on top of other devices, as this could lead to faulty operation. If,
however, it is necessary to use the device in the manner stated,
this device as well as the other devices must be monitored to en-
sure they are working properly.
• The use of accessories other than those specified or provided by
the manufacturer of this device can lead to an increase in electro-
magnetic emissions or a decrease in the device's electromagnetic
immunity; this can result in faulty operation.
• Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should not be used
closer than 30 cm to any part of the device, including cables spec-
ified by manufacturer. Otherwise, degradation of the performance
of this equipment could result.
• Failure to comply with the above can impair the performance of
the device.
HOW TO CONTROL AND REDUCE YOUR PAIN
When should the device be used?
Use as soon as your pain begins. Start with one session.
If you get to your pain early, it may prevent the pain from becom-
ing worse, or even chronic. It's better for you to get it under control
sooner so that it does not reach a high pain threshold where it limits
your daily activities.
Setting the intensity
Intensity is based upon your level of comfort. Begin the first session
with a low intensity and a short duration while learning how to oper-
ate. You should therefore take care to work with maximum intensi-
ties, i.e., always at the limit of what you can support.
Do not exceed your comfort level.
How long should you use the device?
Start with one session. Always turn unit off with pads still on.
Rate your pain to check your progress, 1 low to 15 high. Intensity is
based upon your level of comfort. Begin the first session with a low
intensity and a short duration while learning how to operate. Stop
therapy session if pain has reduced or stopped. If your pain does
not improve and you become sore from over-use, refrain from treat-
ing those areas for 2 days. If this issue reoccurs, reduce the treat-
ment time and intensity settings for future treatment.
Recommended treatment session as following:
You may use the device for once a day.
You may need to use it for longer (maximum 3 times per day and
maximum 90 minutes in total) depending on the level of your pain.
CAUTION
When to stop using the device?
• If you experienced an adverse reaction (skin irritation/redness/
burns, headache or other painful sensation, or if you feel any unu-
sual discomfort).
• If your pain does not improve, becomes seriously chronic and se-
vere, or continues for more than five days.
NOTE
If you feel pain, dizziness, discomfort or nausea, discontinue use of
device and call your physician or medical practitioner.
39