Usage; Using The Main Unit - Beurer EM 70 Gebrauchsanleitung

• If the batteries of the Remote Controller leaks, put on protective
gloves and clean the battery compartment with a dry cloth.
• If the battery of the Main Unit leaks, put on protective gloves and
dispose the device.

9. Usage

9.1 Using the main unit

Attaching the electrode pads and device
Step 1 – Cleaning of skin
Clip excess hair from the treatment area and remove
any jewelry that may come in contact with the stimu-
lation of the device. Wash area with soap and water,
and dry completely.
NOTE
Dirt, grease or particles left on the skin may lodge themselves in the
hydrogel of the electrodes. This has an adverse effect on the adhe-
sive power of the electrodes.
Step 2 – Connect electrode pad
Take off the electrode pad and connect it with the device by attach-
ing the snap button.
NOTES:
Do not use electrodes whose use-by date has expired. The use-by
date is shown on the resealable plastic bag.
Replace the electrodes when they are damaged or dirty, when they
have lost their adhesive power or when stimulation becomes un-
comfortable.
If you use EMS mode, you can connect the extended electrodes to
adapt to different treatment area.(See Electrode Pad Placement for
details). You can also use the extension for TENS or Massage pro-
grammes.
How to use the extended electrodes?
Extended electrodes allow a
alternate of the stimulation
to a group of muscle. When
you connecting the extended
electrodes, the device will run
the alternate muscle stimula-
tion between Group A and
Group B.
Do not apply the electrode
pads 50x50mm on the main
device. Only apply them on the
extension cable.
Do not apply the bigger electrodes on the extension cable. Only the
electrodes with 50x50mm.
WARNING
• Do not plug the extended cable into the main source socket.
NOTE
The cable has grey cable and white cable. The left pad and grey
pad are one group (Group A), the right pad and white pad are other
group (Group B).
29