Technical Data; Installation - IKEA FROSTIG SC136 Bedienungsanleitung

ENGLISH
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.

Technical data

Dimensions
Height
Width
Depth
Net Volume
Defrost System
Energy Consumption
Noise Level
Energy Class

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing
the appliance.
Important! Refer to the assembly instructions
for the installation.
Location
To ensure best performance, install the appli-
ance well away from sources of heat such as
radiators, boilers, direct sunlight etc. Make
sure that air can circulate freely around the
back of the cabinet.
815 mm
596 mm
550 mm
136 Litre
auto
0,321 kWh/24h
35 dB (A)
A+
2. If necessary, adjust the door. Refer to the
assembly instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
The technical informa-
tion are situated in the
rating plate on the in-
ternal left side of the
appliance and in the
energy label.
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but
for optimum performance install this appli-
ance at a location where the ambient tem-
perature corresponds to the climate class in-
dicated on the rating plate of the appliance:
Climate class
SN
N
ST
T
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
12