IKEA FROSTIG SC136 Bedienungsanleitung Seite 5

ENGLISH
If the refrigerant circuit should become
damaged:
– avoid open flames and sources of igni-
tion
– thoroughly ventilate the room in which
the appliance is situated
• It is dangerous to alter the specifications or
modify this product in any way. Any dam-
age to the cord may cause a short-circuit,
fire and/or electric shock.
Warning! Any electrical component
(power cord, plug, compressor) must be
replaced by the After Sales Service agent or
qualified service personnel.
1. Power cord must not be lengthened.
2. Make sure that the power plug is not
squashed or damaged by the back of
the appliance. A squashed or dam-
aged power plug may overheat and
cause a fire.
3. Make sure that you can come to the
mains plug of the appliance.
4. Do not pull the mains cable.
5. If the power plug socket is loose, do not
insert the power plug. There is a risk of
electric shock or fire.
6. You must not operate the appliance
without the lamp cover
lighting.
• This appliance is heavy. Care should be
taken when moving it.
• Do not remove nor touch items from the
freezer compartment if your hands are
damp/wet, as this could cause skin abra-
sions or frost/freezer burns.
• Avoid prolonged exposure of the appli-
ance to direct sunlight.
• Bulb lamps
2)
used in this appliance are
special purpose lamps selected for house-
hold appliances use only. They are not
suitable for household room illumination.
Daily Use
• Do not put hot pot on the plastic parts in
the appliance.
1) If the lamp cover is foreseen
2) If the lamp is foreseen
• Do not store flammable gas and liquid in
• Appliance's manufacturers storage recom-
Care and cleaning
• Before maintenance, switch off the appli-
• Do not clean the appliance with metal ob-
• Regularly examine the drain in the refrig-
Installation
Important! For electrical connection carefully
follow the instructions given in the specific
paragraph.
• Unpack the appliance and check if there
• It is advisable to wait at least four hours
1)
of interior
• Adequate air circulation should be around
• Wherever possible the back of the product
• The appliance must not be located close to
• Make sure that the mains plug is accessible
the appliance, because they may explode.
mendations should be strictly adhered to.
ance and disconnect the mains plug from
the mains socket.
jects.
erator for defrosted water. If necessary,
clean the drain. If the drain is blocked, wa-
ter will collect in the bottom of the appli-
ance.
are damages on it. Do not connect the ap-
pliance if it is damaged. Report possible
damages immediately to the After Sales
Service (refer to "Service"). In that case re-
tain packing.
before connecting the appliance to allow
the oil to flow back in the compressor.
the appliance, lacking this leads to over-
heating. To achieve sufficient ventilation
follow the instructions relevant to installa-
tion.
should be against a wall to avoid touching
or catching warm parts (compressor, con-
denser) to prevent possible burn.
radiators or cookers.
after the installation of the appliance.
5