IKEA FROSTIG SC136 Bedienungsanleitung Seite 11

ENGLISH
Problem
The lamp does not work.
The compressor oper-
ates continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre. You can find the list at the
end of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
Possible cause
The appliance has no power.
There is no voltage in the
mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The door has been opened
too frequently.
The product temperature is
too high.
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
the There is too much water in the
air deflector.
The temperature regulator is
not set correctly.
Solution
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open lon-
ger than necessary.
Let the product temperature
decrease to room temperature
before storage.
Decrease the room tempera-
ture.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Clean the air deflector.
Set a higher/lower tempera-
ture.
1. Remove the
screw from the
lamp cover.
2. Remove the
lamp cover.
3. Replace the
lamp with one
of the same
power and
specifically de-
signed for household appliances. (the
maximum power is shown on the lamp
cover).
11