Cleaning - Steinbach Battery Pro Originalbetriebsanleitung

Stopping cleaning
Cleaning stops automatically when the rechargeable battery is almost drained.
The status indicator blinks yellow while the device travels toward the pool wall. Once it is
at the wall, it is lit solid yellow.
Lifting the device out of the pool
The pump of the device can be damaged if it is switched on or off
outside of the water.
- Only switch the device on or off when it is located below the
water surface.
1. Slowly pull the device to the surface of the water using the hook and a telescopic rod
until you can reach the handle.
2. Slowly lift the device out of the water by the handle and hold it above the water
surface for 10 to 15 seconds so that most of the water can flow back into the pool.
3. Turn off the ON/OFF switch.
The status indicator goes out and the device switches itself off.
4. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued fault-free operation.

Cleaning

Improper cleaning might damage the device.
- Clean the surface of the device with plain water after each use.
- Do not use any aggressive cleaning agents.
- Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
NOTICE!
NOTICE!
37