Operation; Cleaning The Pool - Steinbach Poolrunner Originalbetriebsanleitung

4. Unlatch the hook of the brush strip
from the inside and press the brush
strip out of the bottom part of the
6
filter unit at the same time.
3
5. Take out the brush strip
The brush is taken out.

Operation

Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Do all individual parts function?
- Are the accessories in perfect condition?
- Are all cables in perfect condition?
Do not start up a damaged device or damaged accessories. Have them checked by the
manufacturer or its customer service or a qualified service technician.

Cleaning the pool

Observe the following before cleaning your pool:
- We recommend thoroughly cleaning the device before using it for the first time.
- Remove any cover or film from the pool.
- Remove obstacles (such as a ladder) from the pool.
- Switch off the filter system at least one hour before the start of cleaning so that
particles in the water can settle on the floor.
- Never let the device run outside of the water as this can cause damage even after a
short time.
Proceed as follows to clean your pool:
1. Insert the filter unit.
2. Place the device in the pool.
3. Connect the control unit to the device and the power supply.
4. Start the cleaning cycle.
5. If necessary, adapt the running time of the cleaning cycle to the size of your pool, see
section "Functions of the control unit".
38
6
.
6
6
3
6