Cleaning The Pool - Steinbach Poolrunner APPcontrol Originalbetriebsanleitung

Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Do all individual parts function?
- Are the accessories in perfect condition?
- Are all cables in perfect condition?
Do not start up a damaged device or damaged accessories. Have them checked by the manufacturer or
its customer service or a qualified service technician.

Cleaning the pool

Observe the following before cleaning your pool:
- Remove any cover or film from the pool.
- Remove obstacles (such as a ladder) from the pool.
- Switch off the filter system at least one hour before the start of cleaning so that particles in the
water can settle on the floor.
- Never let the device run outside of the water as this can cause damage even after a short time.
Proceed as follows to clean your pool:
1. Insert the filter units.
2. Place the device in the pool.
3. Connect the control unit to the device and the power supply.
4. Switch the device on, select the desired type of cleaning and adapt the running time to the size of
your pool. See section "Functions of the control unit".
5. Start the cleaning program.
Inserting the filter units
3
1
1. Slide the filter units
2. Press down the handle of the filter units
The filter units are inserted.
36
flush into the device along the guide rail.
1
until it has snapped into place on both sides.
1
4
1