Operation; Cleaning The Pool - Steinbach Twin Originalbetriebsanleitung

Use the TIME button
operation, the LED indicator
blinking.
- 1H stops cleaning after 1 hour.
- 1.5H stops cleaning after 1.5 hours.
- 2H stops cleaning after 2 hours.
ON/OFF function
Use this function to switch the device ON and OFF.
Use the ON/OFF button
- ON switches the device on and starts cleaning at the same time.
- OFF stops cleaning and switches the device off at the same time.

Operation

Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Do all individual parts function?
- Are the accessories in perfect condition?
- Are all cables in perfect condition?
Do not start up a damaged device or damaged accessories. Have them checked by the
manufacturer or its customer service or a qualified service technician.

Cleaning the pool

Observe the following before cleaning your pool:
- We recommend thoroughly cleaning the device before using it for the first time.
- Remove any cover or film from the pool.
- Remove obstacles (such as a ladder) from the pool.
- Switch off the filter system at least one hour before the start of cleaning so that
particles in the water can settle on the floor.
- Never let the device run outside of the water as this can cause damage even after a
short time.
Proceed as follows to clean your pool:
1. Select the filter bags according to the type of soiling.
2. Insert the filter units.
3. Place the device in the pool.
4. Connect the control unit to the device and the power supply.
to switch between the running times. After the start of
13
indicates the currently selected and active mode by
15
14
to switch between the following functions:
14
35