Transport; Functional Description; Commissioning - Abicor Binzel BRS-LC Betriebsanleitung

BRS-LC
A prism and a reamer are required for the initial setup and to ensure the proper function of the torch cleaning station. These
depend on the torch and gas nozzle geometry.
Order the equipment parts and wear parts separately.
The order data and ID numbers for the equipment parts and wear parts can be found in the current product catalog. Contact
details for advice and orders can be found online at www.binzel-abicor.com.

4.1 Transport

Although the items delivered are carefully checked and packaged, it is not possible to fully rule out the risk of transport
damage.
Goods-in inspection
In case of complaints
Packaging for returns Where possible, use the original packaging and the original packaging material. If you have
Tab. 12 Transport
4.2 Storage
Physical storage conditions in a closed environment:
 Tab. 2 Ambient conditions for transport and storage on page EN-6

5 Functional description

In order to be cleaned, the cylindrical part of the torch's gas nozzle is held in the clamping device. The reamer, which is
tailored to the gas nozzle and torch geometry, moves into the gas nozzle interior by means of a stroke movement and
removes adhering weld spatter. At the same time, the gas nozzle interior is cleaned with compressed air blown through the
cable assembly (optional). This air-blast function optimizes the cleaning process.

6 Commissioning

DANGER
Risk of injury due to unexpected start
Improper operation can lead to serious injuries that could result in death.
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTICE
• Note the following instructions:
 2 Safety on page EN-4
• Only qualified personnel are permitted to perform work on the device or system.
BAL.0030.0 • 2021-01-19
Use the delivery note to check that everything has been delivered.
Check the delivery for damage (visual inspection).
If the delivery has been damaged during transport, contact the last carrier immediately.
Retain the packaging for potential inspection by the carrier.
any questions concerning the packaging and/or how to secure an item during shipment,
please consult your supplier.
5 Functional description
EN - 9