Taking Out Of Service And Dismantling; Storage; Disposal; Accessories - Mennekes Amedio Professional+ Serie Betriebs Und Installationsanleitung

10 Taking out of service and
dismantling
The tasks described in this section may only be
carried out by a qualified electrician.
T
CAUTION
Risk of injury from protruding threaded rods
Unsecured protruding threaded rods may lead to falls and
injuries.
f Protect the area of threaded rods against access by
barriers.
Taking the device out of service
f Open the device.
Î "5.3.6 Opening the device"
f Disconnect the supply line and the data line (if applica-
ble).
f Close off the area of threaded rods.
Dismantling the device
f Take the device out of service.
f Loosen the device in the foundation and remove it.
f Run the supply line and the data line (if applicable) out
of the housing.
f Separate the threaded rods, keeping them aligned, or
remove the foundation entirely.
f Close the device.
Î "6.7 Closing the device"

11 Storage

Proper storage can positively affect and maintain
the operability of the device.
f Clean the device before storing.
f Store the device in a clean and dry place in its original
or other suitable packaging.
f Observe permissible storage conditions.
Permissible storage conditions
Storage temperature
Average temperature in
24 hours
Relative humidity

12 Disposal

Discard the device and packaging accord-
ing to regulations at the end of the service
life. Comply with the applicable national
statutory regulations and provisions for dis-
posal and environmental protection in the
country of installation. Old devices and bat-
teries must not be disposed of with house-
hold waste.
f Dispose of packaging material in designated collection
containers.
f Dispose of old devices and batteries via your dealer.

13 Accessories

Information on accessories, e.g. test boxes, can be found
on our website under "Accessories".
https://www.chargeupyourday.com/
-25 °C... + 40 °C
< 35 °C
max. 95 % (non-condensing)
EN
41