Using An Existing Foundation - Mennekes Amedio Professional+ Serie Betriebs Und Installationsanleitung

1
Fig. 7: MENNEKES foundation set and base plate
f Pour concrete into formwork and allow the concrete to
settle. Pour in enough concrete so that the base plate
(4) sufficiently protrudes from the adjacent ground.
f Install the foundation set (1).

Installation manual for foundation set.
f Mount the base plate on the foundation set.
f Insert the foundation set and the base plate in the
formwork.
f Align the foundation set and the base plate.
f Route the supply line (2) and the data line (if applica-
ble) through the hole in the base plate.
f Install foundation earth electrode (3) as per DIN 18014
(e. g. iron strips). Comply with local regulations.
12
2
3
4
Fig. 8: Placing the foundation in concrete
f Fill the bottom two thirds of the foundation with class
C20/25 concrete.
f Allow the concrete to settle.
f Align the base plate (1) horizontally with locking
screws.
f Fill the remaining third of the foundation with low-
shrinkage concrete to enable the base plate to be
seated fully on the concrete. Do not set the base plate
in concrete.
f Allow the concrete to settle.

5.3.2 Using an existing foundation

A base plate that is available separately is required for
mounting the device on an existing foundation.
T
ATTENTION
Corrosion due to damage to powder coating
Drilling through the mounting holes of the base plate will
damage the powder coating and leads to corrosion of the
base plate.
f Use the base plate only as a template for marking the
drill holes.
1