Standalone Autostart" Operating Mode; Standalone With Authorisation" Operating Mode - Mennekes Amedio Professional+ Serie Betriebs Und Installationsanleitung

6.2.1 "Standalone Autostart" operating mode

The device is operated as a stand-alone solution without
connection to a Backend-System. An authorisation is not
required. Charging starts automatically as soon as the
vehicle is plugged in.
f Navigate to the "Settings" menu and set the following
parameters:
Parameter
Connection Type
Free Charging
f When the configuration is concluded, click the "Save &
Restart" button.

6.2.2 "Standalone with authorisation" operating mode

The device is operated as a stand-alone solution with-
out connection to a Backend-System. The authorisation
occurs through RFID cards and an internal Whitelist.
f Navigate to the "Settings" menu and set the following
parameters:
Parameter
Connection Type
Free Charging
If in doubt allow charg-
ing
f Click the "Save" button.
Teach RFID cards by holding in front of RFID card reader
f Navigate to the "Operator" menu and set the following
parameters:
Parameter
Local fixed authorization
list (FLL)
FLL learning mode
22
Setting
f Select "No Backend".
f Select "On".
Setting
f Select "No Backend".
f Select "Off".
f Select "Off".
Setting
f Select "On".
f Select "On".
The function remains active
for 5 minutes
f Hold RFID cards in front of the RFID card reader one
after another.
9
A successfully taught RFID card is confirmed by the
blue LED "Standby" going out temporarily.
The taught RFID UIDs (Unique Identifiers) are displayed in
the parameter "List of entries in FLL" after the web inter-
face has been refreshed (F5). A maximum of 80 RFID UIDs
are displayed.
f Refresh the web interface (F5).
f When the configuration is concluded, click the "Save &
Restart" button.
Teach RFID cards by entering RFID UIDs
To do this, the UIDs of the RFID cards must be known.
f Navigate to the "Operator" menu and set the following
parameters:
Parameter Setting
Local fixed f Select "On".
authorization
list (FLL)
FLL learning f Select "Off".
mode
f Enter RFID-UIDs.
List of entries
in FLL „ Syntax: UID1:UID2:UID3 ...
„ Max. 80 RFID UIDs are displayed
f When the configuration is concluded, click the "Save &
Restart" button.
Delete RFID cards
f Delete all entries of the parameter "List of entries in
FLL".
f Click the "Save & Restart" button.
f Teach authorized RFID cards.
f Click the "Save & Restart" button.