Beurer PM80 Gebrauchsanleitung Seite 39

START/STOP
START/STOP
START/STOP
Downloaded from www.Manualslib.com
tance (meters) in the middle line
during the run.
Please note that the calibration only
applies to the relevant type of pace.
If you change the type of pace, then
this has an effect on the accuracy of
the speed and distance recordings.
End your run. The HR monitor dis-
plays the measured length of the
distance, e.g. 1596 m.
If the displayed value is lower than

the distance covered, increase the
value with
If the displayed value is higher than

the distance covered, decrease the
value with
OPTION/SET
If the calibration was successful
is displayed.
CAL OK
If the distance measured is shorter
than 100 m, i.e. too short for an ac-
curate calibration, the error message
is displayed.
bad Range
is displayed.
CAL Distance
If you would like to leave the menu,
press the button
manuals search engine
.
MENU
.
2 times.
OPTION/SET
38