Beurer PM80 Gebrauchsanleitung Seite 30

Things to know about the recordings
As soon as you have started the recording, your HR monitor

starts recording your training data. Your HR monitor continually
records your training data until you save or delete this. This also
applies when you first start training on the following day. The run-
ning time also allows you to stop your training session at any
time.
If "0" is displayed for a longer period on the display, this means

that the receipt of the signals has been interrupted. In this case
change into the
The HR monitor tries to make contact with the devices once more.
Your HR watch has a memory. You can record up to 23:59:59

hours of your training session. 10 hours of which are stored. You
can record a maximum of 60 laps. A maximum of 50 laps is pos-
sible for each training. Your HR watch informs you if the memory
is almost full. At this point, at the latest, we recommend transmit-
ting the recordings to your PC and thus emptying the memory on
the HR watch. Alternatively you can delete all recordings manu-
ally. Read the section "Delete all recordings" in this chapter to find
out how to delete the recordings.
You can let your training data be displayed. In the

the last recording stopped can be called. In the menu
you can see the laps for this recording.
As soon as you have transferred the recordings into the EasyFit

software, you can view and analyze them there. The memory will
be deleted every time you have successfully transferred the data
to the PC. You can find explanations regarding the transfer of
data to the PC in the chapter "EasyFit Software".
Downloaded from www.Manualslib.com
Training
manuals search engine
menu, by pressing
29
7 times.
MENU
menu,
Result
Lap Result
G
B