Laser Marking - Powerfix Profi Plus PMDL 5 A1 Bedienungsanleitung

Locating wood objects
1.
2.
3.
In this case, search again at a different position in the mode „STUD" and repeat
steps 1 to 3.

Laser marking

You can use laser marking for the exactly horizontal positioning of pictures,
shelves etc.
1.
Horizontal laser line
Exercise caution with the holding pins. They are sharp and can cause injuries.
1.
2.
Downloaded from www.Manualslib.com
Proceed with the search for wood objects as described in the section
„Locating concealed objects".
When the Multi-Measurement Detector has found an object, mark it.
To be sure that the object is wood, slide the material switch
Now search in the same position for metal. Should the Multi-Measurement
Detector not find anything, then the object is wood. Should it find something,
then the object is metal.
The appliance contains a Class 2 laser. NEVER direct the laser beam at
people or animals. NEVER look directly into the laser. The laser can cause
serious eye damage.
Place the function switch
Attention!
Hold the Manifold Measurer horizontally against the wall and align it with
the assistance of the spirit level
two marking lines.
Push both of the holding pins (
The pins lightly bore themselves into the wall so that the appliance
does not fall to the floor. The laser throws a horizontal line onto the wall.
Note:
The holding pins do not function on stone or metal walls.
The walls must have a soft upper surface.
manuals search engine
q
to „LASER". A laser line is projected.
8
. The air bubble must stand between the
5 e
+ ) buttons firmly downwards.
- 46 -
3
to METAL.