Inserting The Battery; Measuring Distances - Powerfix Profi Plus PMDL 5 A1 Bedienungsanleitung

Inserting the battery

1.
2.
3.
Ensure that the wires are not trapped in any way.
This would lead to irreparable damage to the appliance.
4.

Measuring distances

1. Slide the function switch
To switch between the metric and the Anglo-American units of measurement,
press and hold the button MODE
both buttons simultaneously. When you release the buttons, the measurement
units change.
Should the measurement lie outside the measurement range, „Err" or an illogical
number appear in the display. The measurement range lies between 0,6 m (2')
and 16 m (53').
2.
3.
Downloaded from www.Manualslib.com
Open the battery compartment
Detector.
Place the 9 V block battery onto the contacts. Pay heed to the correct polarity.
Lay the tape for removal of the battery underneath the 9 V block battery and
press it into the battery compartment
Important!
Close the battery compartment
with an audible click.
q
Note:
Measurements start at the measurement point
Hold the appliance upright towards the wall to which you wish to measure
the distance. The ultrasound sender/receiver
the wall. For this, use the spirit level: The bubble in the glass
between the marking lines (see Fig. 1).
6
Press the button READ
When you hold the button READ
appliance over the surface to be measured, the appliance continually
measures the distances. These are shown on the display
manuals search engine
t
on the rear side of the Multi-Measurement
t
.
t
. The battery compartment lid must close
to „DISTANCE". The display
4
. Then press the button READ
1
!
0
must be at a right-angle to
. The distance measured appears in the display
6
pressed down and slowly move the
- 41 -
2
switches itself on.
6
and release
8
must stand
2
.
2
.