Measuring volumes
1.
2.
3.
4.
5.
Adding volumes together
1.
2.
3.
4.
5.
6.
7.
8.
9.
Locating concealed objects
Should the appliance find a live wire carrying alternating current,
location! Danger of electric shock!
Downloaded from
www.Manualslib.com
Slide the function switch
2
The display
switches itself on.
4
Press the button MODE
6
Press the button READ
measured length appears and „W" (Width) starts to flash.
6
Press the button READ
measured width appears and „H" (Height) starts to flash.
6
Press the button READ
in the upper line. In the lower line appears the result of the volume calculation.
Measure a volume as described in the section „Measuring volumes".
7
Press the button M
. „M+" appears in the display
The volume measured is now saved.
4
Press the button MODE
measurement.
Measure the next volume.
r
Press the button +/=
. A „+" appears in the display
w
Press the button RM
. The result of the first measurement is shown in the
lower line.
r
Press the button +/=
. Both measurements are added together and
the result is shown in the lower line.
Repeat the steps 2 to 7 to add in further measurement values.
When you wish to leave the addition mode, press the button MODE
All values are erased.
Notice:
• Before using the appliance for this task, first test it by locating a pipeline
or electrical power cable at a known position.
• In cases of doubt, always ask a qualified building contractor.
Attention!
appears in the display. Under no circumstances should you drill at this
manuals search engine
q
to „DISTANCE".
2
twice. In the display
, to measure the length. In the upper line the
to measure the width. In the upper line the
to measure the height. The measured height appears
. The appliance is now ready for the second
- 44 -
flashes „L" (Length).
2
.
2
.
4
.