Werbung
VIEWING IMAGES ON YOUR PLASMA DISPLAY
VISUALISATION DES IMAGES SUR L'ECRAN A PLASMA
BILDWIEDERGABE AUF IHREM PLASMA-DISPLAY
OUT
IN
VIDEO
RS-232C
Main unit
Unité principale
Hauptgerät
Remote control
Commande à distance
STANDBY
Fernbedienung
STANDBY/ON
Remote control
Commande à distance
Fernbedienung
VIDEO
Main unit
Unité principale
Hauptgerät
INPUT
Main unit
Remote control
1
Unité principale
Commande à distance
Hauptgerät
Fernbedienung
STANDBY
STANDBY/ON
2
STANDBY
/ON
12
<ARE1348>
En/Fr/Ge
STANDBY
/ON
INPUT
MENU
ADJUST
SET
STANDBY
/ON
STANDBY
/ON
/ON
V I DEO
STANDBY
/ON
/ON
Input the power to the main unit.
The standby indicator will flash in red for about 4
seconds. The display then enters standby state and
the indicator remains lit.
NOTE :
The buttons on the main unit and remote control unit,
and the external control commands are not accepted
by the display unit while the standby indicator is flash-
ing in red.
Turn on the Display.
The STANDBY indicator turns green.
Select an input source.
• Press the INPUT switching button on the main unit
: each time press changes the input source as fol-
lows:
VIDEO
RGB 2
• To choose an input source with the remote con-
trol, press the INPUT SELECT button.
• The function cannot be switched at the MENU
screen.
"NO SYNC!" is displayed if no signal is being input .
"OUT OF RANGE!" is displayed if the signal being
input cannot be processed on this set.
After use, turn off the power.
1 Turn off the power.
The standby indicator flashes in red for about 4 sec-
onds, then remains lit (standby state).
2 Turn off the MAIN POWER switch on the main
unit.
The STANDBY/ON indicator will dim and the power
to the unit will be turned off.
NOTE :
The buttons on the main unit and remote control unit,
and the external control commands are not accepted
by the display while the standby indicator is flashing
in red.
Do not display the same image (still images, etc.) for
a long time as the image may stick onto the screen.
Y/C
RGB 1
Werbung
Kapitel
Fehlerbehebung
