Viewing Images On Your Plasma Display; Visualisation Des Images Sur L'ecran A Plasma; Bildwiedergabe Auf Ihrem Plasma-Display - Pioneer PDP-V402EA Bedienungsanleitung

VIEWING IMAGES ON YOUR PLASMA DISPLAY

VISUALISATION DES IMAGES SUR L'ECRAN A PLASMA

BILDWIEDERGABE AUF IHREM PLASMA-DISPLAY

1
2
Remote control
Commande à distance
Fernbedienung
3
Remote control
Commande à distance
Fernbedienung
RGB 1
Main unit
Unité principale
Hauptgerät
INPUT
4
Remote control
1
Commande à distance
Fernbedienung
2
12
<ARE1356>
En/Fr/Ge
Downloaded from www.Manualslib.com
STANDBY
/ON
INPUT
MENU
ADJUST
SET
RS-232C
2, 4
STANDBY
/ON
Main unit
Unité principale
Hauptgerät
STANDBY
/ON
STANDBY/ON
Main unit
Unité principale
Hauptgerät
STANDBY
STANDBY/ON
/ON
STANDBY
/ON
manuals search engine
1
Input the power to the main unit.
2, 4
The standby indicator will flash in red for about 4
3
seconds. The display then enters standby state and
the indicator remains lit.
NOTE:
The buttons on the main unit and remote control unit,
and the external control commands are not accepted
by the display unit while the standby indicator is flash-
ing in red.
If the optional video card (PDA-4004) is not installed
properly, the STANDBY indicator blinks as described
1, 4
below to inform the use of abnormality.
• Blinking twice
Only the terminals are installed:
Install the video card.
• Blinking three times
Only the video card is installed:
Install the terminals.
2
Turn on the Display.
3
The STANDBY indicator turns green.
3
Select an input source.
• Press the INPUT button on the main unit. Each time
press changes the input source as follows:
• To choose an input source with the remote con-
STANDBY
trol, press the INPUT SELECT button.
/ON
• The function cannot be switched at the MENU
screen.
"NO SYNC!" is displayed if no signal is being input .
"OUT OF RANGE!" is displayed if the signal being
input cannot be processed on this set.
RGB 1
4
After use, turn off the power.
1 Turn off the power.
The standby indicator flashes in red for about 4 sec-
onds, then remains lit (standby state).
2 Turn off the MAIN POWER switch on the main
unit.
The STANDBY/ON indicator will dim and the power
to the unit will be turned off.
NOTES:
STANDBY • The buttons on the main unit and remote control
/ON
unit, and the external control commands are not ac-
cepted by the display while the standby indicator is
flashing in red.
• Do not display the same image (still images, etc.)
for a long time as the image may stick onto the
screen.
RGB 1
RGB 2