Maintenance Accessories And Products; Maintenance Products; Aquaclean Water Filter; Aquaclean Installation - Saeco HD8919 Bedienungsanleitung

Behaviour
The filter cannot be activated
as the OK signal (V) is not
displayed.
The filter cannot
activated and the machine
asks for descaling.
The filter does not fit.

10. Maintenance accessories and products

10.1 Maintenance products

10.2 AquaClean water filter

10.2.1 AquaClean installation

22
ENGLISH
Cause
A filter has just been activated.
be The series of 8 filter is completed.
The filter has not been replaced on
time after the AquaClean water filter
signal started blinking.
The filter has not been installed right
away upon 1st usage but after having
brewed approx.50 product (based on
100ml cups).
You need to remove air from the filter. Let air bubbles come out of the filter and empty the
There is water in the water tank.
To clean and descale the machine use exclusively Saeco maintenance products.
These products can be purchased in the Philips online shop (if available in your
country) at www.shop.philips.com/service, from your local reseller or from the
authorised service centres.
Should it prove difficult to find the machine maintenance products, please contact the
nearest Philips Saeco hotline in your country. Contacts are included in the warranty
booklet supplied separately or can be found at www.saeco.com/support.
Code
CA6700
CA6903
HD5061
CA6705
CA6706
The SAECO AquaClean water filter purifies the water your machines uses for
brewing coffee. This results in a greater coffee taste. Moreover it prevents mineral
deposits in the water to build up, which eliminates the need of descaling your machine
for 5000* products!
How does the system work?
We recommend you to install the AquaClean water filter at first usage of the machine.
After a period of uses the machine will indicate when the filter needs to be replaced.
In this way you can replace the filter 8 times without the need for descaling. T his equals
approx. 5000* products!
Note: It is however recommended to replace each filter at least after 3 months usage.
After having replaced the filter for the 8th time the machine will ask for descaling.
If you don't install the filter right away upon 1st usage, the machine will ask you to
descale after you have brewed approx 50* products.
(*) based on 100ml cups.
Remove the AquaClean water filter from its packaging, immerse it vertically in cold
>
water, with the opening upwards, and slightly press the sides to let air bubbles out.
>
Insert the AquaClean water filter in the empty water tank. You can leave the small
water filter installed.
>
Push the AquaClean water filter to the lowest possible point.
>
Fill the water tank with fresh water and restore it to the machine.
>
Dispense half the water contained in the tank as detailed in the "6.5.1 Hot water
dispensing" chapter.
You have to dispense at least 10 cups (100 ml x cup)
before activating a new filter. Be careful as if you activate
a new filter, the filter counter will increase automatically.
Descale your machine first as described in the "7.5
Descaling cycle" chapter. Thereafter the filter can
be installed as described in the "10.2.1 AquaClean
installation" chapter.
water tank before installing the filter as described in the
"10.2.1 AquaClean installation" chapter.
SAECO MAINTENANCE PRODUCTS
Product
Descaling solution
AquaClean water filter cartridge
Brew group grease
Milk circuit cleaning system
Maintenance kit
Action