Adjustment Of Milk/Coffee Length In The Cup During Preparation; Hot Water Dispensing Spout - Saeco HD8919 Bedienungsanleitung

MENU
DRINKS
MILK
FROTH
6.3.2

Adjustment of milk/coffee length in the cup during preparation

M
E
M
O
M
E
M
O
M
E
M
O
M
E
M
O
6.4

Hot water dispensing spout

One frothed milk
Press the MENU button.
>
>
Select the DRINKS function and confirm by pressing the OK button.
Scroll the menu to select the MILK FROTH function and confirm by pressing the OK
>
button.
The machine displays the necessary sequence of operations: carafe insertion, milk
frother dispensing spout extraction.
Wait for the necessary pre-heating time. The machine dispenses a preset quantity of
frothed milk to the cup.
>
To stop dispensing, press the OK button. After the product has been brewed, the
machine allows for a quick cleaning of the carafe ducts. Please refer to the "7.4.1 Quick
milk carafe ducts rinse cycle" chapter.
It is possible to adjust the quantity of product brewed according to one's taste and the
size of the cups. This function makes it possible to change the default setting for the
quantity of milk / coffee brewed in the cup.
The carafe must be installed and the milk frother dispensing spout open.
Cappuccino / latte macchiato length
To adjust the cappuccino length, keep the CAPPUCCINO button pressed until the
>
MEMO symbol is displayed, then release the button.
>
Otherwise, to adjust the latte macchiato length, keep the LATTE MACCHIATO
button pressed a few seconds, and release the button when the machine displays
the necessary sequence of operations: carafe insertion, milk frother dispensing spout
extraction. Wait for the necessary pre-heating time. The machine is in the programming
stage and is starting to dispense the frothed milk.
>
Press the OK button as soon as the desired quantity has been reached.
The machine is in the programming stage and is starting to brew coffee.
>
Press the OK button as soon as the desired quantity has been reached.
Now the button is programmed: every time it is pressed, the machine will brew the
product in the quantity just set. After the product has been brewed, the machine
allows for a quick cleaning of the carafe ducts. Please refer to the "7.4.1 Quick milk
carafe ducts rinse cycle" chapter.
Frothed milk length
Follows the previous instructions in the "6.3.1 Brewing a milk-based product" chapter,
"One frothed milk", until the MILK FROTH function is selected.
>
Keep the OK button pressed a few seconds, and release the button when the machine
displays the necessary sequence of operations: carafe insertion, milk frother dispensing
spout extraction.
Wait for the necessary pre-heating time. The machine is in the programming stage and
is starting to dispense the frothed milk.
>
Press the OK button as soon as the desired quantity has been reached.
Now the button is programmed: every time it is pressed, the machine will brew the
product in the quantity just set. After the product has been brewed, the machine
allows for a quick cleaning of the carafe ducts. Please refer to the "7.4.1 Quick milk
carafe ducts rinse cycle" chapter.
Inserting phase
Tilt the water dispensing spout slightly and insert it completely on the machine tracks.
>
>
Press and rotate the water dispensing spout downwards to lock it to the machine.
Removing phase
Press the two side buttons to unlock the dispensing spout and lift it slightly.
>
>
Pull the water dispensing spout to remove it.
11
ENGLISH