Interruption Of The Descaling Cycle; Default Settings; List Of Default Settings; Changing The Default Settings - Saeco HD8919 Bedienungsanleitung

CALC
CLEAN
CALC CLEAN
7.5.1

Interruption of the descaling cycle

START
CALC
CLEAN START
CALC
CLEAN
8.

Default settings

8.1

List of default settings

Display
MAX
COFFEE
MED
TEMP
MIN
180'
60'
STANDBY
30'
15'
DISPLAY
CONTRAST
4
WATER
3
HARDNESS
2
1
WATER
ON
FILTER
0/8 0/8
8.2

Changing the default settings

DISPLAY
CONTRAST
18
ENGLISH
Rinsing phase
Press the OK button to launch the rinse cycle.
>
The cycle can be paused by pressing the ESC button and restarted by pressing the OK
button. This makes it possible for the user to empty the container or leave for a while.
If the water tank was not filled to the MAX level, the machine might require another
rinse cycle. In this case, fill the water tank to the MAX level, put it back in the machine
and repeat the "Rinsing phase".
Let the product be dispensed until the process stops automatically.
>
Press the OK button to exit the descaling cycle. The machine goes through the heating
and automatic rinse process.
>
Remove and empty the container with dispensed water.
Perform the "7.4.3 Weekly cleaning of the milk carafe components" procedure.
Perform the "7.2.1 Weekly brew group cleaning cycle" procedure.
>
You can now install the AquaClean water filter if used: refer to the"10.2 AquaClean
water filter" chapter.
At the end, the machine goes back to the main menu. It is recommended to perform
a "5.2.3 Manual rinse cycle".
Once the descaling cycle has started, you must complete it till the very end without
turning off the machine.
In case you get stuck during the cycle you can exit by pressing the STAND-BY button.
>
>
If this occurs, or in case of power failure or accidental disconnection of the power
cord, empty and rinse carefully the water tank, then fill it up to the CALC CLEAN
level. Follow the instructions provided in the "5.2.3 Manual rinse cycle" chapter before
brewing any product. If the cycle was not completed, the machine will require another
descaling cycle to be performed at your earliest convenience.
Setting Value
Coffee
average
temperature
Stand-by time 15 minutes
Contrast average
4 (very hard
Water hardness
water)
AquaClean water
to be installed
filter
It is possible to customise the machine functions through the programming menu. The
machine must be turned on and ready to work.
If necessary, refer to the "8.1 List of default settings" chapter.
>
Press the MENU button, confirm by pressing the OK button and scroll through
functions list to select the function whose settings are to be modified.
Note: the images at the side refer to a sample function.
>
Press the OK button to select the desired function.
Once selected:
Description
Coffee brewing temperature setting.
Stand-by time setting.
Display contrast setting.
Water hardness setting. For further details, please
refer to the "5.3.1 Water hardness measurement and
setting" chapter.
AquaClean settings. For further details, please refer
to the "10.2 AquaClean water filter" chapter.