The Machine Is Out Of Service; Troubleshooting Table - Saeco HD8919 Bedienungsanleitung

Display
CLEAN
10
START
START
CALC
CALC
CLEAN
CLEAN
9.3

The machine is out of service

XX
Error
Behaviour
code
Coffee grinder
1
blocked
Brew group
3 - 4 locked, cannot be
taken out
Water circuit
5
error
9.4

Troubleshooting table

Behaviour
The machine does not turn
on.
The machine is in simulated
working mode.
The drip tray fills up quickly. To guarantee a perfect coffee at every
The 'Coffee grounds drawer
full' signal is still on, even if
it's emptied or with only few
coffee grounds in it.
20
ENGLISH
Description
The machine is waiting to start the
water circuit priming process.
The milk carafe ducts should be
cleaned.
The machine must be descaled.
The machine is heating up.
The machine is rinsing.
Brew group rebooting.
If the machine error alarm signal is triggered, the error code is displayed in the bottom
right corner of the display.
Please, consult the following table.
Cause
Coffee outlet duct clogged
The brew group is incorrectly
positioned.
Air in the water circuit
For any other error code:
>
Turn the machine off and then back on again after 30 seconds.
>
Try 2 or 3 times.
If the machine does not start, contact the Philips Saeco hotline and mention the error
code shown on the display. Contacts are included in the warranty booklet supplied
separately or can be found at www.saeco.com/support.
Cause
The machine is disconnected or the
main switch is in the OFF position.
The STAND-BY button has been
pressed for more than 8 seconds.
brewing, the machine rinses and warms
itself by flushing water in the drip tray.
The coffee grounds drawer has been
emptied while the machine was off.
Action
Follow the relevant instructions in the "5.2.1 Water
circuit priming" chapter.
Follow the relevant instructions in the "7.4.1 Quick
milk carafe ducts rinse cycle" chapter.
Follow the relevant instructions in the "7.5 Descaling
cycle" chapter.
Wait.
Wait.
Wait.
Action
Clean the coffee outlet duct thoroughly as
described in the "7.2.1 Weekly brew group cleaning
cycle" chapter.
Close the service door. Turn the machine off and
back on again. Wait for the 'Ready for brewing' signal
and then remove the brew group.
Remove and restore the water tank a couple of
times, making sure to position it correctly. Check
that the water tank seat is clean.
Action
Plug in the machine and place the main switch in the
ON position.
Turn the machine OFF and ON using the main switch.
Empty the drip tray. To avoid that rinsing water ends in
the drip tray, place a cup below the dispensing spouts.
After emptying drip tray and coffee grounds drawer,
wait for the 'Close service door' signal to be displayed.
Place the components back.