Brewing Temperature Adjustment; Coffee Dispensing Spout Adjustment; Deactivation And Reactivation; Use - Saeco HD8919 Bedienungsanleitung

5.3.4

Brewing temperature adjustment

MAX
MED
MIN
5.3.5

Coffee dispensing spout adjustment

5.4

Deactivation and reactivation

6.

Use

6.1

Coffee-based preparations

6.1.1

Brewing a product with one button

8
ENGLISH
Refer to the "8.2 Changing the default settings" chapter to change the coffee
temperature default.
The height of the coffee dispensing spout can be adjusted to adapt to the size of the
cup one wishes to use.
>
To adjust the settings, lift or lower the coffee dispensing spout with your fingers.
After 15 minutes in idle mode, the machine goes automatically in stand-by mode. The
start time of the stand-by mode can be changed. To know how, read the "8. Default
settings" chapter.
In this phase the STAND-BY button is flashing.
The machine might launch an automatic rinse/self-cleaning cycle, as described in the
"5.2.2 Automatic rinse/self-cleaning cycle" chapter.
Shutdown
> To turn the machine off completely, the main switch at the back of the machine must
be in the OFF position.
Reactivation
The main switch at the back of the machine must be in the ON position.
>
>
To restart the machine, press the STAND-BY button.
The machine might request a "5.2.1 Water circuit priming", or simply go through an
automatic rinse/self-cleaning cycle as described in the "5.2.2 Automatic rinse/self-
cleaning cycle" chapter.
Make sure to read the "3. Safety" chapter.
In order to preserve product quality, every time the machine is turned on, the "5.2.2
Automatic rinse/self-cleaning cycle" will be launched. When the machine is started after
remaining unused for a long period of time, we recommend running a "5.2.3 Manual
rinse cycle".
The quantity of brewed product in the cup is set by default. To change this value refer
to the "6.1.4 Adjustment of coffee length in the cup during preparation" chapter.
The machine can brew one or two coffee-based drinks.
> Place one cup under the coffee dispensing spout.
One espresso/one espresso lungo
> To brew one espresso, press the ESPRESSO button.
>
Otherwise, to brew one espresso lungo, press the ESPRESSO LUNGO button.
After the pre-infusion cycle, coffee starts pouring from the coffee dispensing spout.
Coffee will be brewed to a preset level; it is possible, however, to stop brewing it
before this level is reached, by pressing the OK button.
After the product has been brewed, the machine goes back to the main menu.