Maintenance Accessories And Products; Maintenance Products; Aquaclean Water Filter - Saeco Incanto HD8914 Handbuch

Behaviour
The frothed milk is too cold. Cups are cold.
Milk does not froth.
The filter cannot be
activated as the OK signal
(V) is not displayed.
The filter cannot be
activated and the machine
asks for descaling.
The filter does not fit.

10. Maintenance accessories and products

10.1 Maintenance products

10.2 AquaClean water filter
20
ENGLISH
Incanto_AMF_EN-IT-DE_Rev01.indb 20
Cause
The milk frother is dirty or incorrectly
placed.
The type of milk used is not suitable
for frothing.
A filter has just been activated.
The series of 8 filter is completed.
The filter has not been replaced on
time after the AquaClean water filter
signal started blinking.
The filter has not been installed right
away upon 1st usage but after having
brewed approx.100 product (based
on 100ml cups).
You need to remove air from the filter. Let air bubbles come out of the filter and empty the
There is water in the water tank.
To clean and descale the machine use exclusively Saeco maintenance products.
These products can be purchased in the Philips online shop (if available in your
country) at www.shop.philips.com/service, from your local reseller or from the
authorised service centres.
Should it prove difficult to find the machine maintenance products, please contact the
nearest Philips Saeco hotline in your country. Contacts are included in the warranty
booklet supplied separately or can be found at www.saeco.com/support.
SAECO MAINTENANCE PRODUCTS
Code Product
CA6700 Descaling solution
CA6903 AquaClean water filter cartridge
HD5061 Brew group grease
CA6704 Degreasing tablets
CA6705 Milk circuit cleaning system
CA6706 Maintenance kit
The SAECO AquaClean water filter purifies the water your machines uses for brewing
coffee. This results in a greater coffee taste. Moreover it prevents mineral deposits in the
water to build up, which eliminates the need of descaling your machine for 5000* products!
How does the system work?
We recommend you to install the AquaClean water filter at first usage of the machine.
After a period of uses the machine will indicate when the filter needs to be replaced.
In this way you can replace the filter 8 times without the need for descaling. T his equals
approx. 5000* products!
Note: It is however recommended to replace each filter at least after 3 months usage.
After having replaced the filter for the 8th time the machine will ask for descaling.
If you don't install the filter right away upon 1st usage, the machine will ask you to
descale after you have brewed approx 50* products.
(*) based on 100ml cups.
Action
Warm the cups with hot water.
Clean the milk frother as described in the "7.4.2
Monthly cleaning of the milk frother components" and
insert it in the machine as shown in the "6.2 Milk
frother" chapter, "Inserting phase".
Read the "6.3 Milk- and coffee-based preparations"
chapter.
You have to dispense at least 10 cups (100 ml x cup)
before activating a new filter. Be careful as if you
activate a new filter, the filter counter will increase
automatically.
Descale your machine first as described in the "7.5
Descaling cycle" chapter. Thereafter the filter can
be installed as described in the "10.2.1 AquaClean
installation" chapter.
water tank before installing the filter as described in
the "10.2.1 AquaClean installation" chapter.
27/03/15 09:58