Aquaclean Replacement; Technical Specifications - Saeco HD8919 Bedienungsanleitung

WATER
FILTER
0/8
ON
0/8

10.2.2 AquaClean replacement

WATER
FILTER
8/8
START
CALC
CLEAN
11. Technical specifications
Description
Housing material
Size (w x h x d)
Weight
Power cord length
Control panel
Cup size
>
Fill the water tank again.
Machine setting phase during the installation
> Press the MENU button, confirm by pressing the OK button and scroll the menu to
go to the 'AquaClean Filter function'.
>
Press the OK button to select the function.
The machine will indicate the number of filters which have been used from 0 up to
8 filters.
>
Press the OK button to confirm the activation otherwise
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for
3 minutes.
The machine is ready for brewing. The AquaClean filter is active.
The number of filters used is automatically updated. After the 8th filter the counting
will restart from 0/8.
After a period of usage the 'AquaClean water filter' signal starts blinking (for
approx.150 products of 100ml). This means that you have to replace it.
The signal will blink faster when it comes close to the expiring time.
Take out the used filter and follow the steps described in chapter "10.2.1 AquaClean
>
installation" chapter.
If you don't replace the filter on time, the machine will ask you to perform a descaling
cycle.
>
In ths case, follow the steps as described below "AquaClean filter replacement after
8 filters used".
AquaClean filter replacement after 8 filters used
Press the MENU button, confirm by pressing the OK button and scroll the menu to
>
go to the 'AquaClean Filter function'.
>
Press the OK button to select the function otherwise
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for
3 minutes.
The machine needs to be descaled as the series of 8 filter is over.
>
Perform the instructions described at the "7.5 Descaling cycle" chapter otherwise
Press the ESC button twice to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for
3 minutes.
At the end, the machine goes back to the main menu.
>
When the main menu is displayed, to replace the filter proceed as described in the
previous "10.2.1 AquaClean installation" chapter.
The machine will restart the counting of the 8 filter series from 0/8.
The manufacturer reserves the right to improve the technical specifications of the
product. All the preset quantities are approximate.
Value
Thermoplastic type
221 x 386 x 430 mm
8 kg
800 - 1200 mm
Front type
Up to 152 mm
23
ENGLISH