Maintenance Accessories And Products; Maintenance Products - Saeco Incanto HD8911 Bedienungsanleitung

Behaviour
The machine grinds the Water empty.
coffee beans, but coffee
does not come out.
The brew group is dirty.
The circuit is not primed.
The coffee dispensing spout is dirty.
The machine must perform the self-
adjustment.
Coffee comes out slowly. Coffee is ground too finely.
The circuit is not primed.
The brew group is dirty.
The machine must perform the self-
adjustment.
The frothed milk is too cold. Cups are cold.
Milk does not froth. The milk frother is dirty or incorrectly
placed.
The type of milk used is not suitable
for frothing.
The filter cannot be A filter has just been activated.
activated as the OK signal
(V) is not displayed.
The filter cannot be The series of 8 filter is completed.
activated and the machine
The filter has not been replaced on
asks for descaling.
time after the AquaClean water filter
signal started blinking.
The filter has not been installed right
away upon 1st usage but after having
brewed approx.50 product (based
on 100ml cups).
The filter does not fit. You need to remove air from the
filter.
There is water in the water tank.

10. Maintenance accessories and products

10.1 Maintenance products

Cause
Fill the water tank and prime the circuit again as
described in the "5.2.1 Water circuit priming" chapter.
Clean the brew group as described in the "7.2.1
Weekly brew group cleaning cycle" chapter.
Prime the circuit as described in the "5.2.1 Water
circuit priming" chapter.
Clean the coffee dispensing spout and its holes using
a toothpick.
Brew a few cups of coffee.
Change coffee blend or adjust the grinding as
described in the "5.3.3 Ceramic coffee grinder
adjustment" chapter.
Prime the circuit as described in the "5.2.1 Water
circuit priming" chapter.
Clean the brew group as described in the "7.2.1
Weekly brew group cleaning cycle" chapter.
Brew a few cups of coffee.
Warm the cups with hot water.
Clean the milk frother as described in the "7.4.2
Weekly cleaning of the milk frother components" and
insert it in the machine as shown in the "6.2 Milk
frother" chapter, "Inserting phase".
Read the "6.3 Milk- and coffee-based preparations"
chapter.
You have to dispense at least 10 cups (100 ml x cup)
before activating a new filter. Be careful as if you
activate a new filter, the filter counter will increase
automatically.
Descale your machine first as described in the "7.5
Descaling cycle" chapter. Thereafter the filter can
be installed as described in the "10.2.1 AquaClean
installation" chapter.
Let air bubbles come out of the filter and empty the
water tank before installing the filter as described in
the "10.2.1 AquaClean installation" chapter.
To clean and descale the machine use exclusively Saeco maintenance products.
These products can be purchased in the Philips online shop (if available in your
country) at www.shop.philips.com/service, from your local reseller or from the
authorised service centres.
Should it prove difficult to find the machine maintenance products, please contact the
nearest Philips Saeco hotline in your country. Contacts are included in the warranty
booklet supplied separately or can be found at www.saeco.com/support.
Action
19
ENGLISH