Monthly Cleaning Of The Milk Carafe (Three Cleaning Cycles); Milk Carafe Cleaning Cycle - Saeco HD8919 Bedienungsanleitung

4
3
5
7.4.4

Monthly cleaning of the milk carafe (three cleaning cycles)

7.4.5

Milk carafe cleaning cycle

16
ENGLISH
• Place the thumb of the other hand on the release button.
• Press the thumb outward.
>
Remove the suction tube (2) from the rubber support (3).
>
Disassemble the milk frother (4) from the rubber support (3).
> Extract the milk frother connection (5) pulling it outwards.
Clean all the components thoroughly with lukewarm water.
>
All the individual components, except the milk container, can be washed in the
dishwasher.
Reassembly phase
Perform the sequence of operations described in the previous "Milk frother dispensing spout
>
disassembly phase" in reverse order and reassemble all the components of the carafe.
>
Before assembling the dispensing spout, move the pin inside the carafe lid manually
to the correct position.
If you cannot assemble the dispensing spout on top of the carafe, it means that the
pin is in the wrong position.
Monthly cleaning of the milk carafe comprises three cleaning cycles carried out in a
sequence: the first cycle requires the use of a specific detergent and water, the second
and third cycles use water alone (simple rinsing).
Perform the sequence of operations described in the "7.4.5 Milk carafe cleaning
cycle" chapter three times in a row, adding the specific detergent to the water the
first time and using water alone the second and third time (two consecutive rinsing
phases). Finally, proceed as described in the "7.4.3 Weekly cleaning of the milk carafe
components" chapter.
The cleaning of the milk carafe entails a cleaning cycle with water alone (simple rinsing).
Disassemble the top of the carafe as shown in the "6.2 Milk carafe" chapter,
"Disassembly phase".
>
Rinse all the components with lukewarm water. Remove all milk residue.
>
Reassemble the milk carafe top.
>
Remove the lid and fill the carafe with fresh water to the MAX level.
>
During the first cleaning cycle add the Saeco milk circuit cleaner and wait for it to
dissolve completely.
>
Place the lid back on the milk carafe.
>
Insert the carafe in the machine as shown in the "6.2 Milk carafe" chapter, "Inserting
phase".
>
Start the milk carafe dispensing spout as detailed in the "6.2 Milk carafe" chapter, "Start
up phase".
>
Place a large container (1.5 l) under the dispensing spout.
Do not drink the solution resulting from the process.
Dispensing phase
Perform the sequence of operations described in the "6.3.1 Brewing a milk-based
>
product", "One frothed milk" chapter.
Burning hazard! At the beginning of each product brewing, milk or steam sprays might
be present. Wait until the end of the cycle before removing the milk carafe.