Reset To The Default Settings; Troubleshooting; Alarm Signals Summary: Red Display; Warnings Signals Summary - Saeco HD8919 Bedienungsanleitung

8.3

Reset to the default settings

RESET
9.

Troubleshooting

9.1

Alarm signals summary: red display

Display
XX
9.2

Warnings signals summary

Display
>
Press the UP button to increase the value.
>
Press the DOWN button to decrease the value.
>
Press the OK button to confirm the change.
When the change has been implemented, the OK message will be displayed.
The modified but unconfirmed values will not be stored.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3 minutes.
It is possible to restore the default settings through the programming menu. The
machine must be turned on and ready to work.
>
Press the MENU button, confirm by pressing the OK button and scroll through
functions list to select the RESET function.
>
Press the OK button to select the function.
When the change has been implemented, the OK message will be displayed.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3 minutes.
This chapter summarises the most common issues that might concern your machine.
If the following information is insufficient to solve the problem, please refer to the FAQ
page of the www.saeco.com/support website, or contact the Philips Saeco hotline.
Contacts are included in the warranty booklet supplied separately or can be found at
www.saeco.com/support.
The machine is colour coded for easier interpretation of the display signals. The colour
code of the symbols is based on the traffic light concept.
Description
Put back the drip tray and coffee
grounds drawer; close the service
door.
Coffee bean hopper empty.
Brew group not inserted.
Coffee grounds drawer full.
Water tank empty.
The machine is out of service.
Description
The machine is ready to brew
products: coffee bean hopper empty.
If the filter signal starts blinking, the
AquaClean filter must be replaced.
Action
Read the "7.1.1 Machine cleaning when needed"
chapter to restore the components to their proper
places.
Follow the relevant instructions in the "4.3 Coffee
bean hopper filling" chapter.
Close the service door. Turn the machine off and
back on again. The brew group automatically returns
to the starting position.
Empty the coffee grounds drawer as described in
the "7.1.1 Machine cleaning when needed" chapter.
Follow the relevant instructions in the "4.2 Water
tank filling" chapter.
Follow the relevant instructions in the "9.3 The
machine is out of service" chapter.
Action
Follow the relevant instructions in the "4.3 Coffee
bean hopper filling" chapter.
Follow the relevant instructions in the "10.2.2
AquaClean replacement" chapter.
19
ENGLISH