Brewing Two Products With One Button; Adjustment Of Coffee Length In The Cup During Preparation; Milk Carafe - Saeco HD8919 Bedienungsanleitung

6.1.2

Brewing two products with one button

2X
2X
6.1.3

Adjustment of coffee length in the cup during preparation

M
E
M
O
M
E
M
O
6.2

Milk carafe

> Place two cups under the coffee dispensing spout.
Two espresso/two espresso lungo
> To brew two espresso, press the ESPRESSO button twice.
>
Otherwise, to brew two espresso lungo, press the ESPRESSO LUNGO button twice.
After the pre-infusion cycle, coffee starts pouring from the coffee dispensing spout.
The machine carries out two grinding cycles in sequence.
Coffee will be brewed to a preset level; it is possible, however, to stop brewing it
before this level is reached, by pressing the OK button.
After the product has been brewed, the machine goes back to the main menu.
It is possible to adjust the quantity of product brewed according to one's taste and
the size of the cups. This function makes it possible to change the default setting for
the quantity of product brewed in the cup. For a stronger taste, reduce the brewed
quantity. Prepare the machine for one espresso / espresso lungo and place a cup
under the coffee dispensing spout.
Espresso length/espresso lungo length
> To adjust the espresso length, keep the ESPRESSO button pressed until the MEMO
symbol is displayed, then release the button.
>
Otherwise, to adjust the espresso lungo length, keep the ESPRESSO LUNGO button
pressed until the MEMO symbol is displayed, then release the button.
The machine is in the programming stage and is starting to brew the chosen
product.
>
Press the OK button as soon as the desired quantity has been reached.
Now the button is programmed: every time it is pressed, the machine will brew the
product in the quantity just set. After the product has been brewed, the machine goes
back to the main menu.
This chapter explains how to use the milk carafe to prepare cappuccino, latte macchiato
or frothed milk. When using the machine for the first time, clean it accurately as
described in the "7.4.5 Milk carafe cleaning cycle" chapter.
Disassembly phase
Press one of the release buttons to remove the top of the carafe.
>
>
Lift the milk carafe top.
Filling phase
Remove the lid.
>
>
Pour the milk in the carafe: the milk level must be kept between the MIN and MAX
levels marked on the carafe. The milk carafe is ready for use.
Reassembly phase
> Assemble the top part of the milk carafe checking that it is well secured.
>
Place the lid back on the milk carafe.
Inserting phase
If installed, remove the water dispensing spout as shown in the "6.4 Hot water
dispensing spout" chapter, "Removing phase".
>
Slightly tilt the milk carafe.
>
Place it completely on the machine tracks.
9
ENGLISH