Warnings Signals Summary; The Machine Is Out Of Service - Saeco Incanto HD8914 Handbuch

Display
XX
9.2

Warnings signals summary

Display
START
START
CALC
CALC
CLEAN
CLEAN
9.3

The machine is out of service

XX
Error
Behaviour
code
Coffee grinder
1
blocked
Brew group
3 - 4 locked, cannot be
taken out
Water circuit
5
error
18
ENGLISH
Incanto_AMF_EN-IT-DE_Rev01.indb 18
Description
Water tank empty.
The machine is out of service.
Description
The machine is ready to brew
products: coffee bean hopper empty.
If the filter signal starts blinking, the
AquaClean filter must be replaced.
The machine is waiting to start the
water circuit priming process.
The machine must be descaled.
The machine is heating up.
The machine is rinsing.
Brew group rebooting.
If the machine error alarm signal is triggered, the error code is displayed in the bottom
right corner of the display.
Please, consult the following table.
Cause
Coffee outlet duct clogged
The brew group is incorrectly
positioned.
Air in the water circuit
For any other error code:
>
Turn the machine off and then back on again after 30 seconds.
>
Try 2 or 3 times.
If the machine does not start, contact the Philips Saeco hotline and mention the error
code shown on the display. Contacts are included in the warranty booklet supplied
separately or can be found at www.saeco.com/support.
Action
Follow the relevant instructions in the "4.2 Water
tank filling" chapter.
Follow the relevant instructions in the "9.3 The
machine is out of service" chapter.
Action
Follow the relevant instructions in the "4.3 Coffee
bean hopper filling" chapter.
Follow the relevant instructions in the "10.2.2
AquaClean replacement" chapter.
Follow the relevant instructions in the "5.2.1 Water
circuit priming" chapter.
Follow the relevant instructions in the "7.5 Descaling
cycle" chapter.
Wait.
Wait.
Wait.
Action
Clean the coffee outlet duct thoroughly as
described in the "7.2.1 Weekly brew group cleaning
cycle" chapter.
Close the service door. Turn the machine off and
back on again. Wait for the 'Ready for brewing' signal
and then remove the brew group.
Remove and restore the water tank a couple of
times, making sure to position it correctly. Check
that the water tank seat is clean.
27/03/15 09:58