Interruption Of The Descaling Cycle; Default Settings; List Of Default Settings; Changing The Default Settings - Saeco Incanto HD8917 Bedienungsanleitung

7.5.1

Interruption of the descaling cycle

START
CALC
CLEAN
START
CALC
CLEAN
8.

Default settings

8.1

List of default settings

Display
MAX
COFFEE
MED
TEMP
MIN
180'
60'
STANDBY
30'
15'
DISPLAY
CONTRAST
WATER
HARDNESS
WATER
FILTER
0/8
8.2

Changing the default settings

DISPLAY
CONTRAST
8.3

Reset to the default settings

RESET
Incanto_OTC_EN-IT-DE_Rev01.indb 19
Perform the "7.2.1 Weekly brew group cleaning cycle" procedure.
>
You can now install the AquaClean water filter if used: refer to the"10.2 AquaClean
water filter" chapter.
At the end, the machine goes back to the main menu. It is recommended to perform
a "5.2.3 Manual rinse cycle".
Once the descaling cycle has started, you must complete it till the very end without
turning off the machine.
In case you get stuck during the cycle or in case of power failure or accidental
>
disconnection of the power cord, you can exit by pressing the STAND-BY button.
>
If this occurs, empty and rinse carefully the water tank, then fill it up to the CALC
CLEAN level. Follow the instructions provided in the "5.2.3 Manual rinse cycle" chapter
before brewing any product. If the cycle was not completed, the machine will require
another descaling cycle to be performed at your earliest convenience.
Setting Value
Coffee
average
temperature
Stand-by time 15 minutes
Contrast average
4 (very hard
4
Water hardness
3
water)
2
1
AquaClean water
ON
to be installed
filter
0/8
It is possible to customise the machine functions through the programming menu. The
machine must be turned on and ready to work.
If necessary, refer to the "8.1 List of default settings" chapter.
>
Press the MENU button and scroll through functions list to select the function whose
settings are to be modified:
Note: the images at the side refer to a sample function.
>
Press the OK button to select the desired function.
Once selected:
>
Press the UP button to increase the value.
>
Press the DOWN button to decrease the value.
>
Press the OK button to confirm the change.
When the change has been implemented, the OK message will be displayed.
The modified but unconfirmed values will not be stored.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3 minutes.
It is possible to restore the default settings through the programming menu. The
machine must be turned on and ready to work.
>
Press the MENU button and scroll through functions list to select the RESET function.
>
Press the OK button to select the function.
Description
Coffee brewing temperature setting.
Stand-by time setting.
Display contrast setting.
Water hardness setting. For further details, please
refer to the "5.3.1 Water hardness measurement and
setting" chapter.
AquaClean settings. For further details, please refer
to the "10.2 AquaClean water filter" chapter.
19
ENGLISH
27/03/15 12:11