Interruption Of The Descaling Cycle; Default Settings; List Of Default Settings - Saeco Incanto HD8914 Handbuch

CALC
CLEAN
CALC
CLEAN
CALC CLEAN
7.5.1

Interruption of the descaling cycle

START
CALC
CLEAN START
CALC
CLEAN
8.

Default settings

8.1

List of default settings

Display
MAX
COFFEE
MED
TEMP
MIN
180'
60'
STANDBY
30'
15'
DISPLAY
CONTRAST
4
WATER
3
HARDNESS
2
1
16
ENGLISH
Incanto_AMF_EN-IT-DE_Rev01.indb 16
Let the water be discharged until the tank is empty.
Remove the water tank and rinse it.
>
>
Fill it with fresh water to the MAX level and return it to its proper place.
>
Remove and empty the container.
Repeat the entire sequence of operations described in the "Preparation phase" above
and proceed with the "Rinsing phase".
Rinsing phase
Press the OK button to launch the rinse cycle.
>
The cycle can be paused by pressing the ESC button and restarted by pressing the OK
button. This makes it possible for the user to empty the container or leave for a while.
If the water tank was not filled to the MAX level, the machine might require another
rinse cycle. In this case, fill the water tank to the MAX level, put it back in the machine
and repeat the "Rinsing phase".
Let the product be dispensed until the process stops automatically.
>
Press the OK button to exit the descaling cycle. The machine goes through the heating
and automatic rinse process.
>
Remove and empty the container with dispensed water.
Perform the "7.4.2 Monthly cleaning of the milk frother components" procedure.
Perform the "7.2.1 Weekly brew group cleaning cycle" procedure.
>
You can now install the AquaClean water filter if used: refer to the"10.2 AquaClean
water filter" chapter.
At the end, the machine goes back to the main menu. It is recommended to perform
a "5.2.3 Manual rinse cycle".
If necessary, place the milk frother back on the steam wand.
> Once the descaling cycle has started, you must complete it till the very end without
turning off the machine.
>
In case you get stuck during the cycle or in case of power failure or accidental
disconnection of the power cord, you can exit by pressing the STAND-BY button.
>
If this occurs, empty and rinse carefully the water tank, then fill it up to the CALC
CLEAN level. Follow the instructions provided in the "5.2.3 Manual rinse cycle" chapter
before brewing any product. If the cycle was not completed, the machine will require
another descaling cycle to be performed at your earliest convenience.
Setting Value
Coffee
average
temperature
Stand-by time 15 minutes
Contrast average
4 (very hard
Water hardness
water)
Description
Coffee brewing temperature setting.
Stand-by time setting.
Display contrast setting.
Water hardness setting. For further details, please
refer to the "5.3.1 Water hardness measurement and
setting" chapter.
27/03/15 09:58