Cleaning The Automatic Milk Frother; Quick Clean Of The Milk System; Daily Cleaning Of The Automatic Milk Frother; Monthly Cleaning Of The Automatic Milk Frother - Saeco HD8914 Bedienungsanleitung

English

Cleaning the automatic milk frother

Apply a thin layer of grease to the rails on both sides see figure .
Insert the brew group as described in section 'Weekly cleaning of the
brew group'.
You can use the grease tube multiple times.

Quick clean of the milk system

Note: After brewing a milk based beverage perform a quick clean of the milk
system.
Place a cup under the automatic milk frother.
Press the HOT WATER button once.
Dispense hot water for
Press the OK button to stop hot water dispensing.

Daily cleaning of the automatic milk frother

Insert the suction tube into a jug filled with fresh water.
Place an empty container under the automatic milk frother. Press the
MILK 5ROTH button.
When the water that flows out of the automatic milk frother is clean,
press the ESC button to stop the dispensing.
Note: If there are still some drops of milk present in the suction tube after
cleaning, remove the suction tube from the jug and dispense steam for
about seconds.

Monthly cleaning of the automatic milk frother

Pour the contents of a Saeco milk circuit cleaning sachet into a jug. Add a
half liter of water.
Insert the suction tube into the jug.
Place a container under the automatic milk frother.
Press the MILK 5ROTH button.
You can press OK to stop or let the machine dispense until it stops
automatically.
Rinse the jug with fresh water and fill it with a half liter of fresh water for
the rinsing cycle. Empty the container and place it back under the
automatic milk frother.
Insert the suction tube into the jug.
Press the MILK 5ROTH button.
You can press OK to stop or let the machine dispense until it stops
automatically.
Disassemble the milk frother see 'Disassembling the automatic milk
frother ' and rinse all parts in lukewarm water or in the dishwasher.
seconds.