Operating Components; Preparations; Inserting/Replacing The Scales Batteries - Silvercrest SKWS 5 A1 Bedienungsanleitung

Operating components

Preparations

Inserting/replacing the scales batteries

■ 6 │
Downloaded from www.Manualslib.com
Mode button
Display
Zero button
Battery compartment
Shift button unit system
1) Turn the scales over and place them on a soft underlay to avoid scratching
the surface.
2) Open the battery compartment
3) Remove the battery separation strips by pulling them out.
4) Reinsert the batteries if necessary and then close the battery compartment
The scales are now ready for use.
NOTE
Insert one lithium button cell battery Type CR 2032 into the battery compart-
ment !
1) Turn the scales over and place them on a soft underlay to avoid scratching
the surface.
2) Open the battery compartment
3) Remove the old battery if inserted. Use a pointed object
to lever the battery out of the compartment.
4) Insert a button cell battery type CR2032. To do this, push one side of the
battery under the battery tab
place. Ensure that the polarity matches the markings on the appliance.
5) Close the battery compartment
NOTE
► If the batteries in the scales become too weak, the display
Please replace the battery in this case.
GB
manuals search engine
.
.
. Push the battery down until it clicks into
.
.
such as a biro
will show "Lo".
SKWS 5 A1