Troubleshooting - Profitec PRO 500 Bedienungsanleitung

•
Regulation (EC) No 2023/2006 on good manufacturing practice for materials and articles
intended to come into contact with food
For compliance, the following harmonized standards have been applied:
•
EN 60335-1:2012 + AC:2014 + A11:2014 + A13:2017
•
EN 60335-2-15:2016 + A11:2018
•
EN 55014-1:2017
•
EN 55014-2:2015
Note: In the event of any changes made to the devices mentioned above without our express permission,
this declaration of conformity will become invalid.

11. TROUBLESHOOTING

Problem
Little or no crema on top of the
coffee
Sparse coffee dispensing, only
drop by drop
The machine is switched on, but
the machine does not work.
Problem
Machine does not heat anymore,
the temperature falls off.
Translation of the German original user manual
Possible cause
The grind is not fine enough
The coffee is too old.
There is too much chlorine in the
water.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The grind is too fine.
There is too much ground
coffee.
The orange control lamp is
switched off: there is not enough
water in the water tank.
Water was refiled, the orange
control lamp is switched off.
The water tank is not fixed
properly.
Possible cause
Is it possible you did not exit the
programming menu on the
display?
Troubleshooting
Use a finer grind setting.
Tamp the ground coffee more
firmly.
Use fresh coffee
Use a chlorine filter.
Use the right coffee amount:
Approx. 7 g 9 g of coffee for
each cup.
Clean the brew group.
Increase the grind setting.
Tamp the ground coffee only
slightly.
Use approx. 7 g 9 g of coffee
for every cup.
Refill water.
Switch on/off the machine.
Make sure that the floater in the
water tank is in the correct
position. (The side of the floater
with the magnet point should
face towards the inside of the
machine. The floater itself
should be
inserted with
the magnet
point on the
upper part of the
floater side.)
Fix the water tank properly.
Troubleshooting
Press in order to leave the
programming mode.
ENGLISH
30