Technical Data; Machine Installation; Preparation For Installation; Electrical Connection - Profitec PRO 500 Bedienungsanleitung

Caution!
Danger of injury: The following parts are hot or may become hot:
• area around the steam handle and the hot water handle
• steam and hot water tube
• portafilter
• brew group
• body (upper part and side frames)

3.2 Technical data

Voltages:
Frequency:
Power:
Water tank:
Measurements:
Measurements
with portafilter:
Weight:

4. MACHINE INSTALLATION

The installation is to be carried out exclusively by qualified specialists, according to the
following instructions and in compliance with valid laws.

4.1 Preparation for installation

• Place the machine on an even and stable surface.
• Make sure that the machine is on a water-resistant surface in case of water spillage
or leakage.
• Never place the machine on hot surfaces.

4.2 Electrical connection

• Make sure that the local main voltage supply corresponds to the information given
on the type plate on the front panel of the espresso machine.
• Make sure that you use the correct power plug for your country.
• Plug the machine into a grounded socket only and do not leave it unattended.
• Do not roll or bend the power cord.
• Do not use an extension cord / do not use a multiple socket.

5. FIRST USE

5.1 First use
Read the instruction manual carefully before operating the machine.
Prior to starting the machine, check if:
• the steam and hot water valves are closed.
• the machine is switched off. (Power switch in lower position.)
• the power cord is disconnected.
• the drip tray is inserted accurately.
• the machine is placed on a water resistant surface.
Translation of the German original user manual
EU: 230 V
UK: 230 V
New Zealand: 240 V
EU: 50 Hz
UK: 50 Hz
New Zealand: 50 Hz
1,400 W
approx. 2.8 l
w x d x h / 302 mm x 447 mm x 393 mm
w x d x h / 302 mm x 555 mm x 393 mm
23.5 kg
Australia: 240 V
US: 115 V
Japan: 100 V
Australia: 50 Hz
US: 60 Hz
Japan: 50/ 60 Hz
ENGLISH
21