Milnor 60044SP2 Wartungsanleitung Seite 29

Table 6: Bearings and Bushings. See
Mark
Do this each
1 2 3 4 5 6
x 200 hours
See Figure 16 for these drive maintenance items. All items take grease EPLF2
x 200 hours
x 200 hours
x 200 hours
x 200 hours
x 200 hours
x 200 hours
See Figure 17 for these door maintenance items. On Staph Guard
x 200 hours
none
x 200 hours
Table 7: Motor Grease Schedule. Use the data in
Motor Identification
(example: main drive)
Table 7 for Motors.
Apply grease to these components to prevent damage.
Component
top and bottom ball bushings,
each Hydrocushion
drive bearings—two places
(front and rear)
bearing seals—two places
(front and rear)
jackshaft bearings (3 places)
idler shaft bearings on Staph
®
Guard models only—two
places
bearing seal for disk brake
assembly on idler
shaft—60044SP2 and
72044SP2 only
brake band bushings—two
places—60044WP2 and
72044WP2 only
side and clean side doors.
door hinge—60044SP2,
72044SP2 and 3-pocket
models
door hinge—60044WP2 and
72044WP2 (Rapid Load
models
door latch plunger
Section 3.1.4.2
Interval Quantity
Years Hours fl oz mL
25
Chapter 3. Routine Maintenance
More Data. See also
"Lubricant Identification and Procedures"
See Figure 20. See also
oz (3.6 mL) of grease EPLF2
Add 0.37 oz (11 mL)
Add 0.12 oz (3.6 mL)
Add 0.12 oz (3.6 mL)
Add 0.31 oz (9.2 mL)
Add 0.12 oz (3.6 mL)
Add 0.06 oz (1.8 mL)
®
models, these items apply to soil
Add 0.12 oz (3.6 mL) of grease EPLF2
(Table 10).
no door hinge grease maintenance necessary
™
)
Apply stick DE3 (Table
to complete this table.
Dates When Grease is Added
PELLERIN MILNOR CORPORATION
Section 3.1.4
Figure 16. Add 0.12
(Table 10)
(Table 10).
10) to surface.
.