Milnor 60044SP2 Wartungsanleitung Seite 27

Table 3: Filters, Screens, and Sensitive Components
Remove contamination from these components to prevent damage and unsatisfactory performance.
Mark
Do this each
1 2 3 4 5 6
x 40 to 60 hours inverter fans, vents, filters
x 600 hours
x 2400 hours
x day*
x 2400 hours
x 200 hours
x 200 hours
x 2400 hours
x 40 to 60 hours breather for bearing
x 200 hours
Table 4: Fluid Containers
Examine. Add fluid if necessary and keep components clean to prevent damage.
Mark
Do this each
1 2 3 4 5 6
x 600 hours
x 2400 hours
x 200 hours
Component
motors
entire machine
chemical inlet areas
strainer in water regulator for
optional supply injector and
pumped chemicals on some
models.
strainer(s) for air inlet
strainer for steam inlet.
(Steam is optional on some
models.)
proximity switches
housing—front and rear
grease relief ports—front and
rear
Component
™
Hydrocushion cylinders
Disk brake reservoir
23
Chapter 3. Routine Maintenance
More Data. See also Section 3.1.3 "How
to Remove Contamination"
See Figure 8. Keep good air flow.
Keep good air flow.
Remove excessive dust and dirt.
Some chemical supplies that stay on machine
surfaces will cause corrosion damage. See
Figure 9 and Section 2.2. "Prevent Damage
From Chemical Supplies and Chemical
Systems"
See Figure 10
See Figure 13
See Figure 12
See Figure 15
See Figure 16
See Figure 16
More Data. See also
"Lubricant Identification and Procedures"
See Supplement 5 and Figure
the oil quality. Remove the used oil if
contaminated. Add the oil given below to
the height of the fill port.
Remove the used oil. Add oil to the height of
the fill port. Add the type of oil that applies to
your machine type (Table
42044_, 60044_, 72044_ = oil 1030
M7_ centrifugal extractor = oil 220
M9_ centrifugal extractor = oil 32
See Figure 21. Examine the oil level and
quality. Add oil Dot3 (Table
If the oil is contaminated, it is necessary to
bleed the brake system. Speak to your dealer
or Milnor. This is not routine maintenance.
PELLERIN MILNOR CORPORATION
Section 3.1.4
20. Examine
10).
10) if necessary.